Function Code; Sending Communication Error List (Function Code 87); Counter Reset After Replacing The Fuser Unit And Paper Feeding Kit (Function Code 88) - Brother DCP-9055CDN Service Manual

1.4.32 Sending communication error list (Function code 87)

<Function>
This function is to send the error list to a service man at a remote location when a FAX
communication error occurs on a user's machine. Reception of the error list enables a service
man to analyze the problem occurring on a user's machine.
<Operating procedure>
- Service side
(1) The service side connects the phone line to the user in question.
- User side
(1) Press the Menu button and Start/Black button as the machine is in the ready state.
(2) Press the 0 button to display "0" on the LCD.
(3) Press the 8 button and 7 button in this order, and "SENDING P.01" is displayed on the
LCD, and the error list is sent.
(4) When the error list is sent, the machine beeps for approximately 1 second and returns to
the initial state of the maintenance mode.
Note:
If this operation is not performed while the phone line is connected, the error list sending
operation is not started. Be sure to perform the operation explained above while the phone
line is connected (i.e., while making a call using the built-in H/S, using the additional
telephone set, or using the line monitor).
1.4.33 Counter reset after replacing the fuser unit and paper feeding kit

(Function code 88)

<Function>
The number of replacement is increased by one, and the warning indication "Replace ***" is
cleared, with implementing this operation after replacing the fuser unit and paper feeding kit.
<Operating procedure>
(1) Press the 8 button twice in the initial state of the maintenance mode.
(2) The "Reset-Fuser Unit" will appear on the LCD.
(3) Press the
"Reset-Fuser Unit"
"Reset-PF KIT"
(4) Press the OK or Start/Black button, then "OK?" will appear on the LCD.
(5) Press the OK or Start/Black button to reset the counter of the selected part and returns
the operating procedure (2) mode.
(6) When the Stop/Exit button is pressed, the machine beeps for one second and returns to
the initial state of the maintenance mode.
or button to select the item you want to reset. The LCD shows.
5-64
Confidential