Cadillac 2008 CTS Owner's Manual page 453

AKENG40_CTS Page 453 Wednesday, July 23, 2008 11:47 AM
2. Peel the protection shield
away from the vehicle to
access the light assembly.
3. Reach through the opening to
disconnect the electrical
connector from the old bulb.
4. Remove the bulb socket from
the lamp housing.
Turn the bulb one-quarter turn
to the left and remove it.
5. Replace the bulb.
6. Connect the electrical
connector to the new bulb.
7. Push the bulb socket into the
lamp housing and turn the
socket one-quarter turn to the
right.
Side Repeater Lights
1. Gently slide the front part of
the light assembly along the
fender toward the rear of the
vehicle.
2. When the tab at the front end
of the assembly disengages
from the fender, pull the front
end of the light assembly
away from the fender.
3. Remove the light assembly
from the fender.
4. Turn the bulb socket to
remove it and replace the
bulb.
5. Insert the socket into the light
assembly and turn it to secure
it.
Section 4
6. Reinstall the lamp assembly.
When reinstalling the light
assembly, align the tab on the
front of the light assembly with
the front edge of the fender
hole, then snap the rear part of
the assembly into the hole in
the fender.
453 . . .
–
–
–
–