Display Messages - Menvier Security TS2500 Operator's Manual

Fault Finding
SYSTEM IS BUSY
PLEASE WAIT
HI SECURE UNSET
12:00 Sun 01 JAN
CODE TAMPER
KEYPAD LOCKED !
Cannot Set
Messages
Sorry,cannot set
Aux X tamp open
Sorry,cannot set
Bell box tamper
Sorry,cannot set
Equipment faulty
Sorry,cannot set
Circuit in fault
Sorry,cannot set
Panel lid tamper

Display Messages

Another user is accessing the alarm system. You
cannot use your keypad until this message has
cleared.
The TS2500 has an high security feature which
can be applied to any ward. When the ward is
unset the remote keypads display "HI SECURE
UNSET" and the high security timer is started. Every
time a detection device is triggered within the
selected ward the timer is reset. However, if no
detection devices within the selected ward are
triggered, the timer will eventually expire. When
the timer expires the ward is automatically set
and the message on the keypads is cleared.
This message is displayed whenever a keypad is
locked out because there has been too many
invalid code entries. This message will clear and
the keypad will unlock itself after 5 minutes.
These messages occur when the system is
unable to set your selected wards.
Cannot set due to a tamper fault on auxiliary
circuit 1 or 2. Clear the fault and if still displayed
contact your alarm company for further advice.
Cannot set due to a tamper fault on the external
sounder. Clear the fault and if still displayed
contact your alarm company for further advice.
Cannot set due to a fault from one or more
system components. The display will indicate the
faulty device. Clear the fault and if still displayed
contact your alarm company for further advice.
Cannot set due to a fault from one or more
circuits. The display will indicate the faulty circuits.
Clear the fault and if still displayed contact your
alarm company for further advice.
Cannot set due to a tamper fault on the control
panel. Clear the fault and if still displayed
contact your alarm company for further advice.