Setting With Circuits In Fault - Menvier Security TS2500 Operator's Manual

Operation
SYSTEM OPEN
17:30 Sun 01 JAN
? ? ? ?
0=SET WARDS
A=Next option
0
Following ccts
are in error :-
Office window
2002 Active
Office door
2001 Active
Clear detectors
e.g. Close Door
& Window
*NO ERROR CCTS*
PRESS ENT TO SET
ENT
.B..............
17:30 Sun 01 JAN

Setting with Circuits in Fault

When starting the exit procedure, any active
circuits, will cause the panel to enter into a
fault mode. Whilst in this mode, the exit
procedure is temporarily suspended.
1.
At the remote keypad enter your
passcode.
2.
Press to set your ward(s) or
0
your wards silently.
3.
The sounder will give a low fault tone and
the exit procedure will be temporarily
suspended, the display will also
automatically show all circuits that are in
fault. Pressing
these circuits.
4.
Check the circuits displayed, when all
circuits show healthy, press
the exit procedure.
5.
Leave the area to be protected by the
designated exit route. The internal
sounder will sound.
6.
Close the final door and press the exit
terminator button (if fitted).
7.
When the internal sounder stops the
ward(s) is set.
.
T his procedure is a programmable
option, and will only be displayed if
enabled by your installation company.
or will scroll through
A C
[
to set
8
to restart