Fault Finding; Display Messages - Menvier Security TS2500 Operator's Manual

Fault Finding

Unset alarms &
Faults
PHONE LINE FAULT
12:00 Sun 01 JAN
MAINS POWER OFF
12:00 Sun 01 JAN
BATTERY FAULT
12:00 Sun 01 JAN
PANEL LID TAMPER
12:00 Sun 01 JAN
AUXILIARY X TAMP
12:00 Sun 01 JAN
BELL TAMPER
12:00 Sun 01 JAN
AUX FUSE BLOWN
12:00 Sun 01 JAN

Display Messages

These messages can occur when your ward
is unset, if accompanied with an internal
alarm they can be silenced by entering your
passcode.
Your alarm system is fitted with a remote
signalling device which is reporting a telephone
line fault. If the fault is not Cleared you may not
be able to set your ward. If the fault persists.
Contact your alarm company for further advice.
There is no mains power to the control panel and
the alarm system is now running on its standby
battery. If the mains power is not restored you
may not be able to set your ward, if the fault
persists the standby battery will eventually run flat.
Contact your alarm company for further advice.
T h e a lar m system s ta ndb y b attery has
developed a fault. If the fault is not cleared you
may not be able to set your ward. Contact your
alarm company for further advice.
The lid of the control panel has been removed. If
the fault is not cleared you may not be able to set
your ward. Contact your alarm company for
further advice.
The control panel has two auxiliary tamper
circuits for monitoring auxiliary devices. The lid of
the device has been removed. If the fault is not
cleared you may not be able to set your ward.
Contact your alarm company for further advice.
The lid of the external sounder has been
removed. If the fault is not cleared you may not
be able to set your ward. Contact your alarm
company for further advice.
The auxiliary supply used for powering detection
devices has blown its fuse. Contact your alarm
company for further advice.