Setting With Circuits Omitted - Menvier Security TS2500 Operator's Manual

Operation
SYSTEM OPEN
17:30 Sun 01 JAN
? ? ? ? ? ? ?
ENT
0=SET WITH OMITS
A=Next option
0
EXIT FOR WARDS:-
A...............
A...............
17:31 Sun 01 JAN

Setting with Circuits Omitted

If you have configured the alarm system to
omit one or more circuits, you may set your
wards with those circuits omitted. For details
on selecting the circuits to be omitted, see
"Omitting Circuits" on page 29. If no circuits
are selected the option to "SET WITH OMITS"
will not appear in the set/unset menu.
1.
At the remote keypad enter your
passcode.
2.
Press to set with circuits omitted. If you
0
want to set without circuits omitted, press
the key until the display shows "0 = SET
A
WARDS".
3.
Leave the area to be protected by the
designated exit route. The internal
sounder will sound.
4.
Close the final door and press the exit
terminator button (if fitted).
5.
When the internal sounder stops the
ward(s) is set and the selected circuits
are omitted.
.
I f the exit tone changes to an alarm
tone, you must re-enter the protected
area and enter your passcode. The
display will show the wards which failed
to set.
When you unset the ward(s) make sure
all previously omitted circuits are armed
before setting the system again, see
"Omitting Circuits" on page 29.