Menvier Security TS2500 Operator's Manual page 38

Fault Finding
Sorry,cannot set
Mains Power off
Sorry,cannot set
Phone line fault
Sorry,cannot set
Payment Required
Sorry, Your code
is locked out
Sorry, Keypad
is locked out
Cannot 'SET'
from this keypad
Cannot 'UNSET'
from this keypad
Display Messages
Cannot set due to no mains power at the control
panel. Clear the fault and if still displayed
contact your alarm company for further advice.
Cannot set due to a phone line fault from your
remote signalling device. Clear the fault and if
still displayed Contact your alarm company for
further advice.
Cannot set due to the expiry of the payment
timer. Contact your alarm company for further
advice.
The TS2500 has a code lock feature which can
be applied to selected users. When the code
lock is in operation the selected users cannot use
their passcode to set or unset their wards.
The remote keypad is locked out and cannot be
used by any users. The lock out is normally
controlled by a key switch or similar.
The remote keypad that you are using to set from
is not assigned to your wards. Use a remote
keypad that is assigned to your wards.
The remote keypad that you are using to unset
from is not assigned to your wards. Use a remote
keypad that is assigned to your wards.