Resetting After An Alarm - Menvier Security TS2500 Operator's Manual

Operation
User Reset
ALARM 2002
15:00.30 01/01
? ? ? ? ? ? ?
ENT
SYSTEM OPEN
15:45 Sun 01 JAN
Engineer Reset
ALARM 2002
15:00.30 01/01
? ? ? ? ? ? ?
ENT
CALL ENGINEER TO
RESET SYSTEM

Resetting after an Alarm

Each ward can be configured to be reset by
one of the following methods:
Full alarms generated in a ward that is
configured as user reset can be reset by any
user that has access for that ward.
From step 5 of "Unsetting after an Alarm":
1.
At the designated remote keypad enter
your passcode.
2.
Press
ESC
3.
Your ward(s) is now reset.
Full alarms generated in a ward that is
configured as engineer reset can only be
reset by the engineer.
From step 5 of "Unsetting after an Alarm".
1.
At the designated remote keypad enter
your passcode. This will silence the reset
warning chime.
2.
Every minute the display will inform you
ESC
of the action to take (normally "CALL
ENGINEER TO RESET SYSTEM" although
your alarm company can change this
to more relevant information).
3.
Contact your alarm company.
.
]