Unsetting The System; Resetting After An Alarm - Menvier Security TS400 Operating Instructions Manual

To unset the system, proceed as follows:
1 Enter the premises via the designate entry door. The
internal sounder will sound.
2 Proceed directly to the keypad and enter all 4 digits of
your passcode.
3 The sounder will stop and the unset indicator will light.
The system is now unset.
If the programmed entry time is exceeded, the
internal sounder will emit an alarm tone for the
duration of the programmed entry time. If a valid
passcode is not entered at the keypad before the
addition time expires, a full alarm will occur, i.e.
internal and external alarm.
When an alarm has occurred the system will require resetting before the system can set again.
Your alarm company will have configured your system to be reset by one of the following
methods:
User Reset:
When an alarm occurs with the system full or part set proceed as follows:
1 Enter the premises via the designate entry route. The
internal sounder will sound.
2 Proceed directly to the keypad and enter all 4 digits of
your passcode.
3 The sounder will stop and the unset indicator will light.
The zone indicators associated with the alarm
condition will also light.
4 Check the system as necessary.
5 Enter your passcode again to reset the system. The
zone indicator that was lit will go out. The system is now
reset.
If after unsetting the system the internal sounder
continues to emits a pulsed tone, the system will
require a reset by either engineer or remote reset. To
silence the pulsed tone, enter your passcode.
For engineer reset telephone:
For remote reset telephone:
4

Unsetting The System

Resetting After an Alarm

Engineer Reset:
Enter the building via the designated
entry point. Proceed directly to the keypad
and enter all 4 digits of your passcode.
? ? ?
The system is now unset.
Remote Reset:
Enter the building via the designated
entry point. Proceed directly to the keypad
and enter all 4 digits of your passcode.
? ? ?
The system is unset and the zone that
caused the alarm is indicated
(e.g. zone 3).
? ? ?
The system is now reset.
?
?
?