Mounting The Camera With The In-Ceiling Set; Mounting Instructions - Mobotix Q25M Manual

Mounting the Camera with the In-Ceiling Set

2.4 Mounting the Camera with the In-Ceiling Set

2.4.1 Mounting Instructions

The In-Ceiling Set offers the most stylish installation option for the Q25M. When properly
installed, the only visible component is a particularly sleek and discreet hemispheric camera,
while most of the remaining components are concealed inside the ceiling.
For these reasons, the Q25M installed with the In-Ceiling Set is the preferred option for
most indoor spaces frequented by customers or the general public (e.g. hotels, restaurants,
banks, retail stores, public buildings, etc.).
The common use of suspended ceilings in commercial and public buildings is an additional
reason to place a preference on in-ceiling installation. The installation process is also
simplified, as the network cable may be laid without difficulty and only a 15 cm diameter
hole must be cut in the ceiling or ceiling component.
Before installing the MOBOTIX Q25M to an indoor location using the In-Ceiling Set, you
must prepare the network connection and drill a hole for the camera:
• Network connection: The network cable is fed through the ceiling directly above
the camera.
When preparing for installation, keep in mind (particularly with regard to cable slack)
that the camera may later need to be repositioned in the correct orientation, accord-
ing to its specific purpose (OBEN / TOP arrow pointing in the direction of the longer
wall for ceiling installation in rectangular rooms).
• Cut a hole for installation: The hole should have a diameter of 150 mm (see drilling
template at the end of the manual).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
83
/156
The decorative ring is
available in different col-
ors and in stainless steel
See Section 2.4,
«Mounting the Camera
with the In-Ceiling Set»
for a detailed description