Mobotix Q25M Manual page 82

82
/156
Q25M Camera Manual: Installation
6. Remove the mounting ring: Separate the black mount-
ing ring from the camera housing (lift the spring clip).
This ring is not required when mounting the camera
to the On-Wall set.
7. Connect the cable: Connect the on-site network cable
to the network cable passing through the On-Wall Set
using a standard connector. Excess cable can be stored
easily within the On-Wall mount.
8. Attach the camera to the mount: The camera must
be seated firmly within the On-Wall mount. The tapered
guides at the back of the camera housing fit exactly
into the openings of the On-Wall mount. Once, again,
ensure that OBEN / TOP arrow points in the correct
direction.
9. Attach the outer shell: Position the outer shell without
the rubber seal and tighten all four Allen screws using
the included Allen wrench.
10. Clean the lens: If necessary, gently clean the front of
the lens with a soft cotton cloth. Do not apply excessive
pressure to the surface of the glass when cleaning the lens.
11. Establish a connection to the camera, check the image: Establish a connection
to the camera as described in Section 3.1 and the following sections. The live
image from the camera should be visible on the computer monitor. Check image
sections on the computer monitor as well.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com