Setting Up Additional Features - Centsys VECTOR2 Installation Manual

20. Setting up additional features

Figure 62 provides the full menu of features that can be set up on the system. Figure 62 provides the full menu of features that can be set up on the system.
Explanation of each feature is provided in the section 'Controller features'. Explanation of each feature is provided in the section 'Controller features'.
When setting up the VECTOR2 system via the LCD display, all the steps that have to be When setting up the VECTOR2 system via the LCD display, all the steps that have to be
followed are clearly provided via the display. It is only necessary to note the following: followed are clearly provided via the display. It is only necessary to note the following:
1. To get into setup mode, press the (oblong) button for three seconds and follow the 1. To get into setup mode, press the (oblong) button for three seconds and follow the
instructions provided from there. instructions provided from there.
2. The buttons provided on the controller for navigating the system, are not marked 2. The buttons provided on the controller for navigating the system, are not marked
because at each step during the Setup, the function given to each button is provided because at each step during the Setup, the function given to each button is provided
on the display. on the display.
S Sens1
S Sens2
M Sens1
M Sens2
Sens+
Sens-
Safe CLS
Safe OPN
Com
LCK/STP
TRG
PED
Com
FRX
LIT
3 3 When not in Setup Mode, ie Normal Mode, the (round) button is used as a TEST When not in Setup Mode, ie Normal Mode, the (round) button is used as a TEST
button for operating the system. The up/down buttons are not used unless the button for operating the system. The up/down buttons are not used unless the
diagnostic screens have been selected to appear in Normal Mode, in which case these diagnostic screens have been selected to appear in Normal Mode, in which case these
buttons allow switching from one screen to the next. buttons allow switching from one screen to the next.
For each feature a factory default setting has been programmed into the For each feature a factory default setting has been programmed into the
controller. Referred to as an Operating Standard or these defaults have been controller. Referred to as an Operating Standard or these defaults have been
determined to suit the requirements of the specific region where the installation determined to suit the requirements of the specific region where the installation
is being carried out. It is only necessary to change a feature where the default is being carried out. It is only necessary to change a feature where the default
does not suit the installation. When selecting any feature in the menu, details of does not suit the installation. When selecting any feature in the menu, details of
the current setting stored in the controller are displayed. the current setting stored in the controller are displayed.
Refer to Table 1 on page 56 for the Schedule of Factory Defaults for each feature Refer to Table 1 on page 56 for the Schedule of Factory Defaults for each feature
3 3 3 3 3
AutoClose AutoClose AutoClose AutoClose AutoClose
Exit Exit Exit Exit Exit Exit Exit Exit Exit Go Go Go Go Go Go Go Go Go
Up/Dn Up/Dn Up/Dn Up/Dn Up/Dn Up/Dn Up/Dn Up/Dn Up/Dn
FIGURE 62. VIEW OF CONTROLLER
Page 42
Menu Level Menu Level