Electrical Setup; Secure Control Box To Wall; Connect All Wiring - Centsys VECTOR2 Installation Manual

12. Electrical Setup

1. Always check that the circuit breaker in the electrical panel is in the
OFF position, and that all high voltage circuits (more than 42.4V)
are completely isolated from the mains supply before doing any
work.
2. Ensure that all low voltage systems (less than 42.4V) are suitably
protected from damage, by disconnecting all sources of power such
as chargers and batteries before doing any work.
3. All electrical work must be carried out according to the
requirements of all applicable local electrical codes. (It is
recommended that a licensed electrical contractor perform such
work.)

Secure control box to wall

1. Secure the control box to wall using the most
appropriate means.
Be sure to position the wall box so as
not to cause any hazards during and
after the installation.
Preferably mount the wall box:
Out of direct sunlight
At a comfortable working height
Away from garden sprinklers etc.
To allow easy access even when
the gate is ope.

Connect all wiring

2. Connect all the cables as required to the
control card. See pages 39 and 40.
3. When wiring each operator back to the
controller housing, it is recommended to
mount a small junction box adjacent each
operator. Terminate the cable provided on
the operator into this junction box and then
route a new cable from the junction box to
the controller housing.
It is recommended that the installer
tie off the harness in such a way so as
to allow for a 350mm loop between
the cable exit at the back of the
operator and either the mounting
bracket or junction box, to minimise
the flexing of the harness. If a sharp
bend is introduced to the cable
harness, or a loop that is less than
350mm in diameter, the resulting
cable fatigue may cause the actuators
to behave erratically or to stop
operating altogether.
Step 1
For wiring diagram see page 39/40
Page 33
FIGURE 50
Wiring Diagram for Basic Operation Wiring Diagram for Basic Operation
THIN PURPLE
S Sens1 S Sens1
S Sens2 THIN BLUE or ORANGE S Sens2
THIN PURPLE M Sens1 PURPLE PURPLE S Sens1 M Sens1
MASTER BLUE BLUE S Sens2
THIN BLUE or ORANGE PURPLE PURPLE M Sense2 PURPLE PURPLE M Sens1 M Sense2
THIN RED or GREY Sens+ BLUE BLUE M Sense2 THIN RED or GREY Sens+
BLUE BLUE Sens+
THIN BLACK Sens- RED RED THIN BLACK Sens-
RED RED Saf CLO BLACK BLACK Sens- Saf CLO
BLACK BLACK Saf CLO
Saf OPE Saf OPE Saf OPE
Com Com Com
LCK/STP LCK/STP LCK/STP
TRG
TRG PED TRG
PED PED
Com
Com FRX Com
FRX LI T FRX
LED
LI T Com LI T
LED Aux 12V LED
Com Com Saf Com
Aux 12V Sol 15 15 Aux 12V
Com Saf Li g ht Com Saf
SLAVE Li g ht 15 15
PURPLE PURPLE Sol Batt + Sol
Li g ht Bat - Li g ht
BLUE BLUE MTR M+
RED RED Li g ht MTR — Li g ht
Batt + Batt +
BLACK BLACK Bat - MTR S+ Bat -
MTR S-
THICK BLUE MTR M+ MTR M+
THICK BLACK MTR — MTR —
MTR S+ THICK BLUE MTR S+
MTR S- THICK BLACK MTR S-
Figure 15 Wiring Diagram Figure 15 Wiring Diagram
Page 36 Page 36 Page 37 Page 37
FIGURE 51
Junction
Box
FIGURE 52