Centsys VECTOR2 Installation Manual page 56

Menu 7 - Pedestrian Opening
This feature is associated with the Ped input on the controller. When activating
this input, the system will open the gate to the pedestrian open position, and
then automatically close after the Pedestrian Autoclose time lapses. If the Ped
connection to Com is maintained, then the gate will remain open, and when the
connection is broken, it will close after the Pedestrian Autoclose time has expired
The time taken for the gate to open to pedestrian is dependent on the pedestrian
pre-open delay and the time required for the gate to close from the pedestrian
position is dependent on the pedestrian pre-close delay
Pedestrian Open Position
Sets the maximum opening of the pedestrian gate in metres, in one
centimetre steps
Pedestrian Autoclose Time
Sets the autoclose time in seconds after a Pedestrian Opening. This time can
be set from zero seconds to four minutes in one second steps.
Pedestrian Pre-open Delay
Sets the time delay between the pedestrian input being activated, and the
gate actually opening. This enhances safety in cases where the pedestrian has
to reach through the gate in order to activate the pedestrian input. A warning
light* would typically be active during this delay. This delay can be set from
zero seconds to four minutes in one second steps
Pedestrian Pre-close Delay
Sets the time delay between the Pedestrian Autoclose timer expiring, and the
gate actually closing. A warning light
delay. This delay can be set from zero seconds to four minutes in one second
steps
*
The warning light is any light wired to the courtesy (pillar) light
contacts, as described in Menu 8, which follows
Menu 8 - Gate lock
An electric strike lock or magnetic lock can be connected to the control card.,
allowing the gate to be locked when closed, open or both.
Lock enable status
Turns the lock functionality on or off
Lock type
Allows selection of either a solenoid strike lock, or a magnetic lock. A solenoid
strike unlocks when power is applied, while a magnetic lock unlocks when
power is removed
Release time
Sets the time period (in seconds) for which the lock remains released after the
gate has started moving
*
would typically be active during this
Page 52