Speech Dialler - Cooper Security i-on 16 Installation And Programming Manual

Programming i-on16
should take place. Next, key in the hour of the day (01 to
24) on which the test call should occur..
To make test calls on one day every month select
Reporting – Alarms – Static Test Call – Monthly. From the
display select a number between 1 and 31 to specify the
day of the month on which the call should take place.
Next, key in the hour of the day (01 to 24) on which the
test call should occur.
For each of the three types of call, the control unit will
add or subtract up to 16 minutes at random to the hour
you specified. This is to make sure that the ARC is not
overwhelmed with a flood of test calls from systems that
have all been given the same time.
Select Reporting – Alarms – Static Test Call – Disabled to
disable static test calls.

Speech Dialler

The I-SD01 has a built-in speech dialler. The module can
record five speech messages using its internal
microphone and replay them to a pre-programmed
telephone number to report an alarm. One message is
called the "Home message", and is always played at the
beginning of a report. You should use this message to
identify the control unit and it's location. The other four
messages allow you to record some indication of the type
of event causing an alarm, for example: "Fire" or "Panic
Alarm". The control unit plays these messages after the
home message.
The control unit can record up to ten seconds of speech
for the Home message, and up to five seconds of speech
for each of the alarm messages.
While programming the speech dialler you link each
message with the specific alarm type you wish to report.
You then select a set of destinations for each message,
and each destination corresponds to one of the telephone
numbers you wish to call (see diagram below).
Page 52