Cooper Security i-on 16 Installation And Programming Manual page 54

Programming
Reset System reset
Exit timeout Exit timeout and restore
Omit Zone omit
RF supervision Zone supervision fail and restore
Radio keypad supervision fail and restore
External siren supervision, fail and restore
RF jamming Jamming fail and restore
RF battery psu Smoke power supply unit fail and restore
Zone low battery fail and restore
Ext Siren low battery fail and restore
Panel battery End station low battery and restore
End station battery missing and restore
Mains Fail Mains fail and restore
Faults Smoke fault and restore
Comms line fault and restore
Installer mode Installer mode start
Installer mode end
Time date reset Time and date reset
Restorals
When you enable a CID Report Group, the control unit
sends the relevant telegram both when an event occurs,
and when the condition causing the event stops. The
second transmission of the telegram is also called a
"restore".
You can enable or disable restoral reporting by selecting
Reporting – Alarms – Restorals. The options available are:
Disabled
Restore off. The control unit does not communicate
restores.
Enabled.
Restore on. The control unit does communicate
restores.
Burg Comms Rearm
This menu option determines what the control unit does
with the "Burg" Fast Format channel 3 at the end of the
siren run time. There are two options:
Disabled
The channel stays active until an Installer or user
resets the system.
Page 50
i-on16
305
457
573
381
344
337
384
338
302
311
301
373
351
627
628
625