Profiles; Language; Restore Defaults; Installer Code - Cooper Security i-on 16 Installation And Programming Manual

Programming
"No" means that the installer/maintainer can enter
the Installer Menu by simply keying in their own
code.

Profiles

This option loads a set of standard entries for all names,
and sets up other options. For details see Appendix. Once
you have loaded the profile you can edit any of the
settings to suit an individual installation.

Language

The control unit can use one of several languages in its
display. To change the language select System Options –
Language.
Changing the language does not affect any stored names
for full/part set, detectors, outputs or users, and does not
change any defaults.

Restore Defaults

Country Defaults
Each country has different settings for alarm reporting.
You can use this option to select default settings for a
given country.
Changing the country does not change the language used
by the display.
Factory Defaults
If you wish to remove all programming from a control
unit (perhaps to re-install it at another site) select this
option.
Note that Factory Defaults sets all reporting defaults to
UK values, changes the language to English, and erases
all names and stored texts. However, selecting Factory
Defaults does not erase the log.

Installer Code

The default Installer access code is 7890. Cooper Security
Ltd recommend that you change this code to some other
number. To change the Installer access code select
System Options-Installer Code.
Page 42
i-on16