Driver Memory Seat - If Equipped; Programming The Memory Feature - Chrysler 2014 Grand Cherokee SRT Owner's Manual

DRIVER MEMORY SEAT — IF
EQUIPPED
This feature allows the driver to store up to two
different memory profiles for easy recall through a
memory switch. Each memory profile contains de-
sired position settings for the driver seat, side
mirrors, and power tilt and telescopic steering
column (if equipped) and a set of desired radio
station presets. Your Remote Keyless Entry (RKE)
transmitter can also be programmed to recall the
same positions when the UNLOCK button is
pressed.
NOTE:
Your vehicle is equipped with two RKE trans-
mitters. One RKE transmitter can be linked to
memory position 1 and the other transmitter
can be linked to memory position 2.
The memory seat switch is located on the
driver's door trim panel. The switch consists of
three buttons:
• The (S) button, which is used to activate the
memory save function
• The (1) and (2) buttons which are used to
recall either of two pre-programmed memory
profiles.
84
1382968-en-2014_GRAND_CHEROKEE_SRT_EE+14WK742-126-ENG-AA/DIV_Owners_Manual_v1
PAGE POSITION: 86
Memory Seat Switch

Programming The Memory Feature

NOTE:
To create a new memory profile, perform the
following:
Vehicles Equipped With Keyless
Enter-N-Go
1. Without pressing the brake pedal, push the
ENGINE START/STOP button and cycle the
ignition to the ON/RUN position (Do not start the
engine).
JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror, power tilt
and telescopic steering column [if equipped],
and radio station presets).
3. Press and release the S (Set) button on the
memory switch.
4. Within 5 seconds, press and release either
of the memory buttons (1) or (2). The Electronic
Vehicle Information Center (EVIC) will display
which memory position has been set.
Vehicles Not Equipped With Keyless
Enter-N-Go
1. Insert the ignition key fob, and turn the
ignition switch to the ON/RUN position.
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror, adjustable
pedals [if equipped], power tilt and telescopic
steering column [if equipped], and radio station
presets).
3. Press and release the S (Set) button on the
memory switch.