Driver Memory Seat - If Equipped - Chrysler PACIFICA 2018 User Manual

Stowed Seat Belt
3. To abort seat operation while seat is in motion,
push a different seat position selector switch to
stop the seat. Once the seat stops moving, then
the desired position can be selected.
4. The third row power seat system includes ob-
stacle detection. When the system detects an
obstacle, the motors will stop and reverse direc-
tion. Should this occur, remove the obstacle be-
fore pushing the button again.
Driver Memory Seat — If Equipped
The Memory Buttons (1) and (2) on the driver's
door panel can be programmed to recall the driver's
seat, outside mirrors, and radio station preset set-
tings. Your key fobs can also be programmed to
recall the same positions when the unlock button is
pushed.
Driver Memory Switch
Your vehicle may have been delivered with two key
fobs, one key fob can be linked to each of the
memory positions.
Programming The Memory Feature
To create a new memory profile, perform the follow-
ing:
1. Cycle the vehicle's ignition to the ON/RUN po-
sition (do not start the engine).
2. Adjust all memory profile settings to desired
preferences (i.e., driver's seat, outside mirrors
and radio station presets).
3. Push and release the set (S) button on the
memory switch.
4. Within five seconds, push and release either of
the memory buttons (1) or (2). The instrument
cluster display will show which memory position
has been set.
NOTE:
• Memory profiles can be set without the vehicle in
PARK, but the vehicle must be in PARK to recall a
memory profile.
• To set a memory profile to your key fob, refer to
"Linking And Unlinking The Remote Keyless En-
try Key Fob To Memory" in this section.
35