Chrysler 2014 Grand Cherokee SRT Owner's Manual page 55

If you are installing ISOFIX-compatible child re-
straints in adjacent rear seating positions, you can
use the ISOFIX anchors or the vehicle's seat belt
for the outboard position, but you must use the
vehicle's seat belt at the center position. If your
child restraints are not ISOFIX-compatible, you
can only install the child restraints using the
vehicle's seat belts. For typical installation instruc-
tions, refer to "Installing The ISOFIX-Compatible
Child Restraint System".
Installing The ISOFIX-Compatible Child
Restraint System
We urge you to carefully follow the directions of
the manufacturer when installing your child re-
straint. Not all child restraint systems will be
installed as described here. Again, carefully
follow the installation instructions that were pro-
vided with the child restraint system.
The rear seat lower anchorages are round bars,
located at the rear of the seat cushion where it
meets the seatback, and are just visible when
you lean into the rear seat to install the child
restraint. You will easily feel them if you run your
finger along the intersection of the seatback and
seat cushion surfaces.
1382968-en-2014_GRAND_CHEROKEE_SRT_EE+14WK742-126-ENG-AA/DIV_Owners_Manual_v1
In addition, there are top tether strap anchor-
ages behind each rear seating position located
on the back of the outboard seats. To access
the top tether strap anchorages behind the rear
seat, pull the carpeted floor panel away from the
seat back, this will expose the top tether strap
anchorages.
PAGE POSITION: 55
ISOFIX Anchorages
JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_
Pulling Down The Carpet Floor Panel To
Access Top Tether Strap
Top Tether Strap Anchorage (Located on
Seatback)
53