Parksense® Front And Rear Park Assist - If Equipped - Chrysler 2014 Grand Cherokee SRT Owner's Manual

CAUTION!
• ParkSense® is only a parking aid and it is
unable to recognize every obstacle, includ-
ing small obstacles. Parking curbs might
be temporarily detected or not detected at
all. Obstacles located above or below the
sensors will not be detected when they are
in close proximity.
• The vehicle must be driven slowly when using
ParkSense® in order to be able to stop in time
when an obstacle is detected. It is recom-
mended that the driver looks over his/her
shoulder when using ParkSense®.
120
PAGE POSITION: 122
1382968-en-2014_GRAND_CHEROKEE_SRT_EE+14WK742-126-ENG-AA/DIV_Owners_Manual_v1
WARNING!
• Drivers must be careful when backing up
even when using ParkSense®. Always check
carefully behind your vehicle, look behind
you, and be sure to check for pedestrians,
animals, other vehicles, obstructions, and
blind spots before backing up. You are re-
sponsible for safety and must continue to pay
attention to your surroundings. Failure to do
so can result in serious injury or death.
• Before using ParkSense®, it is strongly rec-
ommended that the ball mount and hitch ball
assembly is disconnected from the vehicle
when the vehicle is not used for towing.
Failure to do so can result in injury or
damage to vehicles or obstacles because
the hitch ball will be much closer to the
obstacle than the rear fascia when the loud-
speaker sounds the continuous tone. Also,
the sensors could detect the ball mount and
hitch ball assembly, depending on its size
and shape, giving a false indication that an
obstacle is behind the vehicle.
JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_
PARKSENSE® FRONT AND
REAR PARK ASSIST — IF
EQUIPPED
The ParkSense® Park Assist system provides
visual and audible indications of the distance
between the rear and/or front fascia and a de-
tected obstacle when backing up or moving for-
ward, e.g. during a parking maneuver. Refer to
ParkSense® System Usage Precautions for limi-
tations of this system and recommendations.
ParkSense® will retain the last system state
(enabled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense® can be active only when the shift
lever is in REVERSE or DRIVE. If ParkSense®
is enabled at one of these shift lever positions,
the system will remain active until the vehicle
speed is increased to approximately 7 mph
(11 km/h) or above. The system will become
active again if the vehicle speed is decreased to
speeds less than approximately 6 mph (9 km/h).