To Set A Desired Acc Speed; To Cancel; To Turn Off; To Resume - Chrysler 2014 Grand Cherokee SRT Owner's Manual

To Set A Desired ACC Speed

When the vehicle reaches the speed desired,
push the SET + button and release. The EVIC
will display the set speed.
Remove your foot from the accelerator pedal. If
you do not, the vehicle may continue to accel-
erate beyond the set speed. If this occurs:
• The message "ACC DRIVER OVERRIDE"
will display in the EVIC.
• The system will not be controlling the dis-
tance between your vehicle and the vehicle
ahead. The vehicle speed will only be deter-
mined by the position of the accelerator
pedal.
When you remove your foot from the accelera-
tor pedal ; the vehicle speed will go back to the
set speed, or to the speed of the target vehicle
whose speed is less than the set speed.

To Cancel

The following conditions cancel the system:
• The brake pedal is applied.
• You depress the brake pedal.
PAGE POSITION: 105
1382968-en-2014_GRAND_CHEROKEE_SRT_EE+14WK742-126-ENG-AA/DIV_Owners_Manual_v1
• You press the CANCEL switch.
• An Anti-Lock Brake System (ABS) event
occurs.
• A Trailer Sway Control (TSC) event occurs.
• The transmission is shifted into NEUTRAL.
• The Electronic Stability Control/Traction Con-
trol System (ESC/TCS) activates.
• The vehicle parking brake is applied.
• The driver switches ESC to full-off mode.
NOTE:
If ACC is resumed or set with the ESC/TCS
off, ESC will automatically be re-engaged.

To Turn Off

The system will turn off and clear the set speed
in memory if:
• You push the Adaptive Cruise Control (ACC)
ON/OFF button.
• You push the Normal (Fixed Speed) Cruise
Control ON/OFF button.
• You turn OFF the ignition.
• You switch to Four-Wheel Drive Low.
JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_

To Resume

If there is a set speed in memory press the RES
(resume) button and then remove your foot from
the accelerator pedal. The EVIC will display the
last set speed.
NOTE:
You can resume ACC from a minimum of
19 mph (30 km/h).
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to
follow these warnings can result in a collision
and death or serious personal injury.
103