Seats; Driver Memory Seat - If Equipped - Chrysler 300 2018 User Manual

SEATS

Seats are a part of the Occupant Restraint System
of the vehicle.
WARNING!
• It is dangerous to ride in a cargo area, inside or
outside of a vehicle. In a collision, people rid-
ing in these areas are more likely to be seri-
ously injured or killed.
• Do not allow people to ride in any area of your
vehicle that is not equipped with seats and
seat belts. In a collision, people riding in these
areas are more likely to be seriously injured or
killed.
• Be sure everyone in your vehicle is in a seat
and using a seat belt properly.
20
Driver Memory Seat — If Equipped
This feature allows the driver to store up to two
different memory profiles for easy recall through a
memory switch. Each memory profile contains de-
sired position settings for the driver seat, side mir-
rors, and power tilt and telescopic steering column
(if equipped) and a set of desired radio station
presets. Your key fob can also be programmed to
recall the same positions when the unlock button is
pushed.
NOTE:
Your vehicle is equipped with two key fobs, one key
fob can be linked to memory position 1 and the
other key fob can be linked to memory position 2.
The memory seat switch is located on the driver's
door trim panel. The switch consists of three but-
tons:
• The set (S) button, which is used to activate the
memory save function.
• The (1) and (2) buttons which are used to recall
either of two pre-programmed memory profiles.
Programming The Memory Feature
NOTE:
To create a new memory profile, perform the fol-
lowing:
1. Cycle the vehicle's ignition to the ON/RUN po-
sition (do not start the engine).
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror, power tilt and
telescopic steering column [if equipped], and
radio station presets).
3. Push and release the set (S) button on the
memory switch.
4. Within five seconds, push and release either of
the memory buttons (1) or (2). The instrument
cluster display will display which memory posi-
tion has been set.
NOTE:
• Memory profiles can be set without the vehicle in
PARK, but the vehicle must be in PARK to recall a
memory profile.
• To set a memory profile to your key fob, refer to
"Linking And Unlinking The Remote Keyless En-
try Key Fob To Memory" in this section.