Chrysler 2014 Grand Cherokee SRT Owner's Manual page 80

Vehicles Equipped with Remote Start
On models that are equipped with remote start,
the driver's heated seat and heated steering
wheel can be programmed to come on during a
remote start. Refer to "Remote Starting System
— If Equipped" in "Things To Know Before
Starting Your Vehicle" for further information.
Front Heated Seats With Uconnect® 5.0 —
If Equipped
There are two heated seat switches that allow
the driver and passenger to operate the seats
independently. The controls for each heater are
located in the Uconnect® system screen.
You can choose from HIGH, LOW or OFF heat
settings.
Press the "Climate" hard-key located on the
right side of the Uconnect® display.
Press the "Driver" or "Passenger" seat soft-key
once to select HI-level heating. Press the soft-
key a second time to select LO-level heating.
Press the soft-key a third time to shut the
heating elements OFF.
78
1382968-en-2014_GRAND_CHEROKEE_SRT_EE+14WK742-126-ENG-AA/DIV_Owners_Manual_v1
PAGE POSITION: 80
NOTE:
Once a heat setting is selected,
heat will be felt within two to
five minutes.
When the HI-level setting is selected, the heater
will provide a boosted heat level during the first
four minutes of operation. Then, the heat output
will drop to the normal HI-level. If the HI-level
setting is selected, the system will automatically
switch to LO-level after a maximum of 60 min-
utes of continuous operation. At that time, the
display will change from HI to LO, indicating the
change. The LO-level setting will turn OFF
automatically after a maximum of 45 minutes.
Front Heated Seats With Uconnect®
8.4A/8.4AN — If Equipped
There are two heated seat soft-keys that allow
the driver and passenger to operate the seats
independently. The controls for each heater are
located in the Uconnect® system screen.
Press the "Controls" soft-key located on the
bottom of the Uconnect® display.
JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_
Press the "Driver" or "Passenger" seat soft-key
once to select HI-level heating. Press the soft-
key a second time to select LO-level heating.
Press the soft-key a third time to shut the
heating elements OFF.
NOTE:
Once a heat setting is selected,
heat will be felt within two to
five minutes.
When the HI-level setting is selected, the heater
will provide a boosted heat level during the first
four minutes of operation. Then, the heat output
will drop to the normal HI-level. If the HI-level
setting is selected, the system will automatically
switch to LO-level after a maximum of 60 min-
utes of continuous operation. At that time, the
display will change from HI to LO, indicating the
change. The LO-level setting will turn OFF
automatically after a maximum of 45 minutes.