Chrysler 2014 Grand Cherokee SRT Owner's Manual page 116

WARNING!
Forward Collision Warning (FCW) is not in-
tended to avoid a collision on its own, nor
can FCW detect every type of potential col-
lision. The driver has the responsibility to
avoid a collision by controlling the vehicle via
braking and steering. Failure to follow this
warning could lead to serious injury or death.
Turning FCW ON Or OFF
NOTE:
The default status of FCW is "On", this
allows the system to warn you of a possible
collision with the vehicle in front of you.
The forward collision button is located on the
switch panel below the Uconnect® display.
To turn the FCW system OFF, press the forward
collision button once to turn the system OFF
(led turns on).
To turn the FCW system back ON, press the
forward collision button again to turn the system
ON (led turns off).
114
PAGE POSITION: 116
1382968-en-2014_GRAND_CHEROKEE_SRT_EE+14WK742-126-ENG-AA/DIV_Owners_Manual_v1
Changing the FCW status to "Off" prevents the
system from warning you of a possible collision
with the vehicle in front of you.
Changing the Active Braking status to "Off"
prevents the system from providing limited au-
tonomous braking, or additional brake support if
the driver is not braking adequately in the event
of a potential frontal collision.
NOTE:
The FCW system state is kept in memory
from one key cycle to the next. If the system
is turned OFF, it will remain off when the
vehicle is restarted.
Changing FCW And Active Braking Status
To change the FCW and Active Braking set-
tings with Uconnect® 8.4/8.4A System
Screen — if equipped.
NOTE:
The settings can only be changed when the
vehicle is in PARK.
JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_
Follow these steps to set the FCW and Active
Braking:
1. Press the "Controls" soft-key located on the
bottom of the Uconnect® display.
2. Press the "Settings" soft-key.
3. Press the "Safety & Driving Assistance" soft-
key.
4. Press the "FWD Collision Warning", Far or
Near soft-key for your desired preference.
5. Press the "Active Braking" On or Off soft-key.
NOTE:
A check mark will appear in the selection
box to indicate the setting.
To change the FCW and Active Braking set-
tings with Uconnect® 5.0 System Screen —
if equipped.
NOTE:
The settings can only be changed when the
vehicle is in PARK.