Keyless Enter-N-Go; Normal Starting - Chrysler 2014 Grand Cherokee SRT Owner's Manual

Keyless Enter-N-Go™

This feature allows the
driver to operate the ig-
nition switch with the
push of a button, as long
as the Remote Start/
Keyless Enter-N-Go™
Key Fob is in the pas-
senger compartment.

Normal Starting

Using The ENGINE START/STOP Button
1. The transmission must be in PARK or NEU-
TRAL.
2. Press and hold the brake pedal while press-
ing the ENGINE START/STOP button once.
3. The system takes over and attempts to start
the vehicle. If the vehicle fails to start, the starter
will disengage automatically after 10 seconds.
4. If you wish to stop the cranking of the engine
prior to the engine starting, press the button
again.
PAGE POSITION: 205
1382968-en-2014_GRAND_CHEROKEE_SRT_EE+14WK742-126-ENG-AA/DIV_Owners_Manual_v1
NOTE:
Normal starting of either a cold or a warm
engine is obtained without pumping or
pressing the accelerator pedal.
To Turn Off The Engine Using ENGINE
START/STOP Button
1. Place the shift lever/shift selector in PARK,
then press and release the ENGINE START/
STOP button.
2. The ignition switch will return to the OFF
position.
3. If the shift lever/shift selector is not in PARK,
the ENGINE START/STOP button must be held
for two seconds and vehicle speed must be
above 5 mph (8 km/h) before the engine will
shut off. The ignition switch position will remain
in the ACC position until the shift lever/shift
selector is in PARK and the button is pressed
twice to the OFF position. If the shift lever/shift
selector is not in PARK and the ENGINE
START/STOP button is pressed once, the EVIC
(if equipped) will display a "Vehicle Not In Park"
message and the engine will remain running.
Never leave a vehicle out of the PARK position,
or it could roll.
JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_
NOTE:
If the ignition switch is left in the ACC or
RUN (engine not running) position and the
transmission is in PARK, the system will
automatically time out after 30 minutes of
inactivity and the ignition will switch to the
OFF position.
Keyless Enter-N-Go™ Functions – With
Driver's Foot OFF The Brake Pedal/Clutch
Pedal (In PARK Or NEUTRAL Position)
The Keyless Enter-N-Go™ feature operates
similar to an ignition switch. It has four positions,
OFF, ACC, RUN and START. To change the
ignition switch positions without starting the
vehicle and use the accessories follow these
steps.
• Starting with the ignition switch in the OFF
position:
• Press the ENGINE START/STOP button
once to change the ignition switch to the ACC
position (EVIC displays "IGNITION MODE
ACCESSORY"),
203