Parksense® Sensors; Parksense® Warning Display; Parksense® Display - Chrysler 2014 Grand Cherokee SRT Owner's Manual

ParkSense® will retain the last system state
(enabled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense® can be active only when the shift
lever is in REVERSE. If ParkSense® is enabled
at this shift lever position, the system will remain
active until the vehicle speed is increased to
approximately 7 mph (11 km/h) or above. The
system will become active again if the vehicle
speed is decreased to speeds less than ap-
proximately 6 mph (9 km/h).
ParkSense® Sensors
The four ParkSense® sensors, located in the
rear fascia/bumper, monitor the area behind the
vehicle that is within the sensors' field of view.
The sensors can detect obstacles from approxi-
mately 12 in (30 cm) up to 79 in (200 cm) from
the rear fascia/bumper in the horizontal direc-
tion, depending on the location, type and orien-
tation of the obstacle.
116
PAGE POSITION: 118
1382968-en-2014_GRAND_CHEROKEE_SRT_EE+14WK742-126-ENG-AA/DIV_Owners_Manual_v1
ParkSense® Warning Display
The ParkSense® Warning screen will only be
displayed if Sound and Display is selected from
the Customer - Programmable Features section
of the Uconnect® System. Refer to "Uconnect®
Settings" in "Understanding Your Instrument
Panel" for further information.
The ParkSense® Warning screen is located
within the Electronic Vehicle Information Center
(EVIC). It provides visual warnings to indicate
the distance between the rear fascia/bumper
and the detected obstacle. Refer to "Electronic
Vehicle Information Center (EVIC)/Settings" in
Understanding Your Instrument Panel" for fur-
ther information.
ParkSense® Display
When the vehicle is in REVERSE, the EVIC will
display the park assist ready system status.
JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_
Park Assist Ready
The system will indicate a detected obstacle by
showing a single arc in the left and/or right rear
regions based on the object's distance and
location relative to the vehicle.
If an object is detected in the left and/or right
rear region, the display will show a single arc in
the left and/or right rear region and the system
will produce a tone. As the vehicle moves closer
to the object, the display will show the single arc
moving closer to the vehicle and the tone will
change from a single 1/2 second tone to slow, to
fast, to continuous.