Lane Change Assist; High/Low Beam Switch; Windshield Wiper Operation; Windshield Wipers And Washers - Chrysler 2014 Grand Cherokee SRT Owner's Manual

Lane Change Assist

Tap the lever up or down once, without moving
beyond the detent, and the turn signal (right or
left) will flash three times then automatically turn
off.
Flash-To-Pass
You can signal another vehicle with your head-
lights by partially pulling the multifunction lever
toward the steering wheel. This will cause the
high beam headlights to turn on until the lever is
released.

High/Low Beam Switch

Push the multifunction lever toward the instru-
ment panel to switch the headlights to high
beam. Pulling the multifunction back toward the
steering wheel will turn the low beams back on,
or shut the high beams off.
WINDSHIELD WIPERS AND
WASHERS
The windshield wiper/washer controls are lo-
cated on the multifunction lever on the left side
of the steering column. The front wipers are
1382968-en-2014_GRAND_CHEROKEE_SRT_EE+14WK742-126-ENG-AA/DIV_Owners_Manual_v1
operated by rotating a switch, located on the
end of the lever. For information on the rear
wiper/washer, refer to "Rear Window Features"
in "Understanding The Features Of Your Ve-
hicle".

Windshield Wiper Operation

Rotate the end of the lever to one of the first four
detent positions for intermittent settings, the fifth
detent for low wiper operation and the sixth
detent for high wiper operation.
PAGE POSITION: 95
Multifunction Lever
JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_
Windshield Wiper Operation
CAUTION!
Always remove any buildup of snow that
prevents the windshield wiper blades from
returning to the "park" position. If the wind-
shield wiper switch is turned off, and the
blades cannot return to the "park" position,
damage to the wiper motor may occur.
93