Installing Memory Modules; Required Tools; Preliminary Steps - Fujitsu Primergy CX270 S2 Upgrade And Maintenance Manual

Main memory
7.2

Installing memory modules

Upgrade and Repair Units (URU)
Average task duration: 5 minutes
7.2.1

Required tools

Preliminary and concluding steps:
●
– Phillips PH2 / (+) No. 2 screw driver
Installing memory modules: tool-less
●
7.2.2

Preliminary steps

Perform the following steps:
"Disabling SVOM boot watchdog functionality" on page 65
Ê
Ê Locate the desired server node.
"Shutting down the server node" on page 43
Ê
Ê If applicable, remove all external cables from the server node.
"Removing the server node from the server enclosure" on page 44
Ê
"Disconnecting the BBU from the controller" on page 216
Ê
"Removing the cables" on page 45
Ê
"Removing a TESLA GPGPU card" on page 140
Ê
"Removing the air duct" on page 46
Ê
"Removing the GPGPU riser module" on page 48
Ê
"Removing the air duct brackets" on page 49
Ê
"Removing the memory slot air ducts" on page 50
Ê
Ê Identify the correct memory slot according to the mounting order described
in section "Memory sequence" on page
228 Upgrade and Maintenance Manual
(if applicable)
224.
(if applicable)
CX270 S2