Enabling Boot Watchdog Functionality; Enabling Replaced Components In The System Bios - Fujitsu Primergy CX270 S2 Upgrade And Maintenance Manual

Basic software procedures
5.2.3

Enabling boot watchdog functionality

If ServerView Operation Manager boot watchdog functionality has been
disabled for firmware upgrade purposes (see section
watchdog functionality" on page
maintenance task.
Timer settings can be configured in the BIOS.
Configuring boot watchdog settings in the BIOS
Ê Enter the BIOS.
Ê Select the Server Mgmt menu.
Ê Under OS Watchdog Timer select the Enabled setting.
Ê Save your changes and exit the BIOS.
I
For detailed information on how to access the BIOS and modify settings,
refer to the "System Board D3196 BIOS Setup Utility" reference manual.
5.2.4

Enabling replaced components in the system BIOS

When a processor, an expansion card, or a memory module fails, the defective
component will be set to Disabled or Failed. The server will then reboot with only
the intact hardware components remaining in the system configuration. After
replacing the defective component, it needs to be re-enabled in the system
board BIOS.
Ê Enter the BIOS.
Ê Select the Advanced menu.
Ê Select the status menu of the desired component:
– Memory: BIOS -> Chipset -> Northbridge -> DIMM enable / disable
Ê Reset replaced components to Enable.
Ê Save your changes and exit the BIOS.
I
For detailed information on how to access the BIOS and modify settings,
refer to the "System Board D3196 BIOS Setup Utility" reference manual.
74
65), it has to be re-enabled to complete the
Upgrade and Maintenance Manual
"Disabling SVOM boot
CX270 S2