Installing A Memory Module; Concluding Steps - Fujitsu Primergy CX270 S2 Upgrade And Maintenance Manual

7.2.3

Installing a memory module

Figure 151: Installing memory modules (A)
Ê Press out the securing clip at each end of the memory module connector.
Figure 152: Installing memory modules (B)
Ê Press down on the memory module until the securing clips snap into the
cutouts at each end of the module.
V
CAUTION!
Install dummy modules in not used memory slots.
7.2.4

Concluding steps

Perform the following steps:
"Installing the memory slot air ducts" on page 51
Ê
"Installing the air duct brackets" on page 53
Ê
"Installing the GPGPU riser module" on page 54
Ê
"Installing the air duct" on page 55
Ê
"Installing a TESLA GPGPU card" on page 130
Ê
CX270 S2
Upgrade and Maintenance Manual
Main memory
(if applicable)
229