Installing The Cables - Fujitsu Primergy CX270 S2 Upgrade And Maintenance Manual

Hide thumbs Also See for Primergy CX270 S2:

Table of Contents

Installing the cables

Figure 17: Installing the cables

Ê Connect the cables to the SAS/SATA and SGPIO connectors onboard or on

the interposer board (1).

Ê Run the cables through to the cable clamps (2).

Ê Connect the 3-pin cable to the 3-pin connector onboard (3).

Ê Connect the cables to the SAS onboard connectors or, if applicable, to the

SAS RAID controller connectors (4).

Upgrade and Maintenance Manual

Basic hardware procedures