4.3
Removing the cables
I
Disconnect all cables from the SAS/SATA connectors onboard and from
the SAS RAID controller (if applicable).
Figure 3: Removing the cables
Ê Disconnect the cables from the SAS/SATA and SGPIO connectors onboard
or on the interposer board (1).
Ê Remove the cables from the cable clamps (2).
Ê Disconnect the 3-pin cable from the onboard connector (3).
Ê Disconnect the cables from the SAS onboard connectors or, if applicable,
from the SAS RAID controller connectors (4).
CX270 S2
Upgrade and Maintenance Manual
Basic hardware procedures
45