Installing The Slot Bracket; Concluding Steps - Fujitsu Primergy CX270 S2 Upgrade And Maintenance Manual

Expansion cards, interposer boards and battery backup units
6.3.2.4

Installing the slot bracket

V
CAUTION!
Always replace slot brackets into the unused PCI slot openings to comply
with applicable EMC regulations and satisfy cooling requirements.
Figure 52: Installing the slot bracket
Ê Install the slot bracket (1).
Ê Secure the slot bracket with the screw (2).
Screw type: 6-32 x 4.7 mm
6.3.2.5

Concluding steps

Perform the following steps:
"Installing SAS RAID controller" on page 114
Ê
"Installing the riser module" on page 60
Ê
"Installing the cables" on page 57
Ê
I
For a complete cabling overview, please refer to section
overview" on page
CX270 S2
(if applicable)
304.
Upgrade and Maintenance Manual
(if applicable)
"Cabling
109