Flush-Mounted Installation; Change Of Nameplates; Signaling Overview - Linkcom Link Door Phone User Manual

Door phone intercom
Table of Contents

Advertisement

1.2.2 Flush-Mounted Installation

The FMBBxN mounting box is built-in wall. Be careful in orientation of assembling holes when nearly MK1 square
box is used – it must be in vertical axis. The well-embedded box is shown on figure.
The Protecting Frame (provides overlapping of unevenness after
mounting box walling-in) and Canopy (necessary for installation in external
areas) form other accessories for flush-mounted installation. When installed
in surroundings with possible water condensation (temperature changes) or
water spraying (rain) it is recommended to connect the jumper on Main
module – heating ON.
The board heating has two positive functions partly it heats up the
electronics in winter at temperatures below –20°C (most details with
extended temperature range has guaranteed parameters from –20°C) and
partly with external installation at swift temperature changes and higher air
humidity by Relayed heating no water condensation occurs on Main
Doorphone board, which assures its reliable function.

1.3 Change of nameplates

The first step is dismantling of a fixing frame from module, where we want to change a nameplate. It can be
executed by unscrewing of two screws under plastic covers on fixing frame. When removing the fixing frame we can
see two independent modules. The front part (metallic) of the button module has to be first separated from plastic part
in this way that we will put off the plastic lug, ensuring the front part on the right side. Each button has its separate
nameplate hold by means of plastic flag (see figure). The paper nameplates can be printed from Excel form or from
Nset setting program.

1.4 Signaling Overview

The LINK DOOR PHONE sends acoustic signals during operation. Another signaling can be done by means of
red LED (placed under microphone hole). You can also listen the signaling samples in Nset program setting.
Condition
Line lifting up
Line hanging up
Report after calling
Command confirmation from
phone
Dialing
Call
Notice about call end
Entry to programming from
phone
Programming from phone
Parameter confirmation
Entry to programming from PC
Programming from PC
All rights are reserved to Linkcom
Tones
Tone frequency
–▄–■–▀–
425-850-1275
–▀–■–▄
1275-850-425
–▄–■–▀–
425-850-1275
––█––
425
DTMF/Pulse
–■–■–■–
1275
–■–■–■–
850
––▓–▓–––––
mod. 850
––█––
–■–■–■–
850
classe
DR
LINK DOOR PHONE
LED
glows
goes
out
glows
goes
out
glows
glows
glows
glows
glows
glows
blinks
Number
classement
LinkDoor
001
– Installation and Operating Instructions
date
page
15/04/05
8/31

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Link Door Phone and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Slimdoorphone 1 button

Table of Contents