Parameter 52
d – Time setting for communication between Door
Phone and PABX
Time can be extended during conversation by
dialing from phone (* or #) befor or when hearing
hanging up signal
Parameter 51
q – Laps of time signaled by tone befor the Door Phone
pick up the line
Doorphone lifts up among rings namely 2 sec. after
detection q – times rings (The number can be set
from 1 to 9)
Parameter 53
w – max.
time
[sec]
presses [range
1-9]
Direct Call Buttons (U4N,M4N)
Keypad UCKN
Parameter 54
z – time in [sec] for which the Doorphone will hang up,
before repeated dialing (ex: re-activating direct call
button during a call or dialing or after busy tone
detection) [range 1-5]
All rights are reserved to Linkcom
among
button
classe
Parameter 57
t–DTMF tone duration is determined by
the formula:
entered number + 5) x 10 = tone
duration [ms]
Parameter 58
m–Gap duration among DTMF tones is
determined by the formula:
entered number + 5) x 10 = gap
duration [ms]
Parameter 59
f–Flash duration is determined by the
formula:
entered number x 100 = Flash
duration [ms]
Parameter 50
p – pause duration is determined per
Parameter 55
z – time in [sec] after Doorphone lifting
Parameter 56
h – After finishing the dialing, number of KVT
(ringing tones) is being counted. If the
number exceeds h value, it will hang up
[range 04-99]. The dialing is repeated in case
Group 1/Group 2 has been set.
classement
LinkDoor
DR
formula:
entered number x 100 = pause
duration [ms]
up before dialing [range 1-5]. This
time is different for each exchange,
but
most
exchanges
manage to process dialing up to 2
seconds after line lifting up.
Number
date
15/04/05
001
usually
page
22/31
Need help?
Do you have a question about the Link Door Phone and is the answer not in the manual?