Related Manuals for Linkcom Link IP iDP Cam
Summary of Contents for Linkcom Link IP iDP Cam
- Page 1 Link IP iDP Cam Quick User Guide v1 Please find the latest version of the manual and firmware at : www.linkcom.fr CLAMART–...
-
Page 2: Table Of Contents
Index 1. Physical install ................................3 1.1. Opening the door phone ..............................3 1.2. Dismounting of nameplate ............................... 3 2. Wall mounting ................................3 2.1. Dimension ....................................3 2.2. Surface mounting ................................. 4 2.3. Flush mounting ..................................4 3. Description of components ........................... 5 3.1. -
Page 3: Physical Install
1. Physical install 1.1. Opening the door phone Using the tool provided, unscrew the screw, as shown below and remove the cover: 1.2. Dismounting of nameplate Remove the 4 screws of the transparent protection. Make the appropriate changes on the nameplate and mount the protection using 4 screws. -
Page 4: Surface Mounting
2.2. Surface mounting Using 3 screws and plugs, fix the doorphone to the wall: 2.3. Flush mounting The dimensions of the flush part are: Height: 182mm • Width: 104mm • Depth: 22mm • Using 3 screws and plugs, fix the doorphone to the wall: p.4 | 23... -
Page 5: Description Of Components
• 3.1. PoE or Power Supply For Link IP iDP Cam is necessary used PoE power from switch or the AC voltage of 11-15V or DC voltage of 12-15V, not exceed 300mA. In practice the alternating feeder 12V/1A mostly meets these demands. -
Page 6: Relay Connection
DIP switch setting basic operation and default setting. See on picture 4. State of DIP switch is reading at start the Link IP iDP Cam. After get started system is necessary DIP switch 3 and 4 always return to the position "On", because at next reboot system would be new values overwriting by default value. -
Page 7: Setting
4.1. P2P or SIP server Mode The Link IP iDP Cam works in P2P or SIP server mode. The mode setting depends on the Dip Switch position. In SIP server mode it is possible to register the doorphone to IP-PBX or SIP operator. -
Page 8: Sip Setting
4.4. SIP setting The Link IP iDP Cam can be set to peer to peer (P2P) mode or SIP server mode by setting the DIP switch (page 8). In P2P mode Link IP iDP Cam calls IP address in « memory number» (page 15). -
Page 9: Operation Testing
Press a button, the IP Link iDP Cam must call the extension number previously configured. 5.2. Incoming call : The Link IP iDP Cam accepts incoming calls. Upon receiving a SIP call, it picks up on the first ring by default.