Table of Contents
Advertisement
Parameter
41.
v – Dialing mode
v = 0 Tone (DTMF) mode,
v = 1 Pulse (DC) mode
Parameter 47
e – e = 0 selected numbers from Group
1/Group 2 mode. Door phone will switch
automatically from Group 1 to Group 2
numbering plan when numbers of ring set
in parameter 84 is riched
e = 1 selected numbers from Day/Night
mode. Door phone will wait for a manual
switching from Day to Night mode
numbering plan or when the same
buttons is redialled.
Parameter 42
z – Sign for call extension * or #
(10sec
before
Doorphone will send a signal,
then the call may be extended by
dialing either * or #)
Parameter 6#
s = 0 Main module is fitted with 2 buttons as standard
s = 1 Main module is fitted with 1 button
s = 2 Main module is feeted with no button
S0 setting is a factory one, no service can change it and so it is
recommended not to change this parameter.
Note: In remote mode the value of this parameter is checked
and if not satisfactory form unknown reasons, so it is set up to s
= 0 (fitted with 2 buttons).
All rights are reserved to Linkcom
call
end
the
Parameter 43
g – command order [1-2] (two commands in
order to hang up the Doorphone using both
Relayes)
bb –
command for
[2 digits]
phone
The advantage is to set the same command both
for
Relay
command Doorphone hanging up aa=bb.
Parameter 45 et 46
dd – Prefix for DAY mode switching [2
digits]
nn – Prefix for NIGHT mode switching [2
digits]
Parameter 49
o – o = 0 dialing as on normal phone (all number
of called person should be dialled on keypad).
o =1 Only 2-digit from memory tablevare
dialed on keypad
ATTENTION !! This parameter setting will sharply
influence keypad function
classe
classement
LinkDoor
DR
Doorphone
hanging up from
activation
(parameter
Parameter 48
c – c = 0 No keypad
connected to the
Main module
c
=
UCKN
on the first position
c
=
UCKN
on
position
c
=
Parameter 44
xxxx
– Password for
remote mode
programming
Number
date
15/04/05
001
35)
and
1
keypad
connected
2
keypad
connected
the
second
3
Keypad
page
20/31
Advertisement
Table of Contents
Need help?
Do you have a question about the Link Door Phone and is the answer not in the manual?