Mounting The Fp-20Xx To A Panel - National Instruments FieldPoint FP-2000 User Manual

Mounting the FP-20xx to a Panel

© National Instruments Corporation
Follow these steps if you choose to install the optional FieldPoint network
panel-mount accessory and mount the FP-20xx network module to a panel.
You can order the panel-mount accessory, part number 777609-01, from
National Instruments.
1. Write down the serial number from the back of the FP-20xx before you
mount it.
2. Use a flathead screwdriver to open the rail clip to the unlocked
position, as shown in the following figure.
1
1 Rail Clip Locked
3. Snap the panel-mount accessory onto the module, as shown in the
following figure.
4. Lock the panel-mount accessory into place by pushing the rail clip to
the locked position.
Chapter 2
2 Rail Clip Unlocked
2-7
Installing the Hardware and Software
2
FP-2000/2010/2015 User Manual