National Instruments FieldPoint FP-2000 User Manual page 63

If the FP-20xx does not have access to a Domain Name Server (DNS), do not use
Note
domain name entries in the RT Target Access List. Requests to resolve the domain name
© National Instruments Corporation
permitted access even though the list indicates by the * wildcard that all
addresses ending in
.test.site.com
next to a list entry denotes that access is permitted, while an
access is denied. If no entry matches the host PC address, access is denied
unless you supply a password.
Table 5-1 shows examples of RT Target Access List entries and provides
information about the * wildcard and permitting matching access entries.
To specify an Internet host address, enter its domain name or IP address.
Use the * wildcard when specifying Internet host addresses. For example,
you can specify all hosts within the domain
* . You can specify all hosts in the subnet whose first two
.site.com
numbers are 130.164 with the entry
addresses.
Table 5-1. Example RT Target Access List Entries
Access String
*
test.site.com
*
.site.com
130.164.123.123
*
130.164.123.
In the RT Target: Access dialog box previously shown, all hosts in
the domain can target the RT Engine, with the exception
site.com
of all hosts in the
test.site.com
,
a.test.site.com
can target the RT Engine. The host
access, even though it is in the
The default RT Target: Access settings permit any host machine to target
the RT Engine on the FP-20xx without a password.
Chapter 5
are denied access. A checkmark
130.164.
All hosts
The host whose domain name is
test.site.com
All hosts whose domain names end
with
.site.com
The host with the IP address
130.164.123.123
All hosts whose IP addresses start
with
130.164.123
domain. Additionally, the hosts
, and
b.test.site.com
public.site.com
domain.
site.com
5-5
LabVIEW RT Programming
denotes that
X
with the entry
site.com
*. The entry * matches all
Matches
130.164.123.123
does not have
FP-2000/2010/2015 User Manual
also