National Instruments FieldPoint FP-2000 User Manual page 20

© National Instruments Corporation
4. To add more terminal bases, repeat steps 1 through 3, mating the local
bus connectors of each new terminal base to the connector of the last
installed base. In most cases a single FP-20xx can support up to nine
terminal bases, depending on the power consumption of the I/O
modules. Refer to the
for more information about power requirements.
If all the pilot holes were correctly drilled, the local bus connectors
should remain firmly mated after all the bases are mounted to the
panel.
Chapter 2
Wiring Power to the FieldPoint System
2-9
Installing the Hardware and Software
section
FP-2000/2010/2015 User Manual