Appendix E
Specifications
Physical Characteristics
Environmental
Safety
Electromagnetic Compatibility
For full EMC compliance, you must operate this device with shielded cabling. In
Note
addition, all cover and filler panels must be installed. See the Declaration of Conformity
FP-2000/2010/2015 User Manual
Screw-terminal wiring ............................16–26 AWG copper conductor
Torque for screw terminals.....................0.5–0.6 N ⋅ m (4.4–5.3 lb ⋅ in.)
Weight ....................................................278 g (9.8 oz)
FieldPoint modules are intended for indoor use only.
Operating temperature ............................–25 to 55 °C
Storage temperature ................................–40 to 85 °C
Humidity .................................................10 to 90% RH, noncondensing
Maximum altitude...................................2,000 m
Pollution Degree .....................................2
The FP-20xx meets the requirements of the following standards for safety
and electrical equipment for measurement, control, and laboratory use:
•
EN 61010-1:1993/A2:1995, IEC 61010-1:1990/A2:1995
•
UL 3101-1:1993, UL 3111-1:1994, UL 3121:1998
•
CAN/CSA c22.2 no. 1010.1:1992/A2:1997
CE, C-Tick and FCC Part 15 (Class A) Compliant
Electrical emissions ................................EN 55011 Class A at 10 m FCC
Electrical immunity ................................Evaluated to EN 61326: 1997/A1:
wire with 7 mm (0.28 in.) of
insulation stripped from the end
Part 15A above 1 GHz
1998, Table 1
E-2
ni.com