National Instruments FieldPoint FP-2000 User Manual page 31

Chapter 3 Hardware and Software Configuration
FP-2000/2010/2015 User Manual
• Gateway—The IP address of a device that acts as a gateway
server, which is a connection between two networks.
• DNS Address—The IP address of a network device that stores
host names and translates them into IP addresses.
8. Enter values on the System tab of the System Configuration dialog
box, shown in the following figure.
• Host Name—This is the name that appears for the device
when you browse the network using Remote System Explorer.
Refer to the Giving Your FP-20xx a Host Name
Appendix A,
about using this name on your network.
• Comment—To help you identify your FP-20xx.
• Password-protect Resets—Determines whether the user is
allowed to reset the FieldPoint bank remotely. If this checkbox is
selected, the user must provide the password in order to reset
the system remotely. Refer to the
Remote System Explorer
a password. You must disable resets from FieldPoint Explorer
separately by setting user access to Read Only or Deny Access.
Refer to the Setting Up Security for the FP-20xx section for more
information.
Choosing Network Settings, for more information
Locking/Unlocking Settings in
section for information about specifying
3-4
section of
ni.com