Finding And Configuring Devices And Channels - National Instruments FieldPoint FP-2000 User Manual

Chapter 3 Hardware and Software Configuration

Finding and Configuring Devices and Channels

FP-2000/2010/2015 User Manual
11. Highlight the module and click Select. When the new host name or
IP address appears in the Comm Resource Configuration dialog box of
FieldPoint Explorer, you can proceed to configuring your devices and
channels.
After you have configured the FP-20xx in FieldPoint Explorer, follow these
steps to configure your FieldPoint devices and channels.
1. In the Comm Resource Configuration dialog box, click Find Devices
to search for all of the FieldPoint devices on this communications
resource. If the Comm Resource Configuration dialog box is not
already open, right-click the Comm Resource in FieldPoint Explorer
and select Edit this comm resource.
If no devices are found, refer to the
FieldPoint Explorer
No Modules Found Error in
section of Appendix C, Troubleshooting.
3-6 ni.com