Evaporator Tie-In; Figure 1-11 Micro-Channel Style Condenser Assembly; Table 8-3 Split--System Gen--5 With Micro--Channel Condenser - Carrier Transport Air Conditioning Installation Procedures Manual

CLOSE-UP VIEW
COIL FINS
Table 8-2 SPLIT SYSTEM REFRIGERANT AND OIL CHARGING TABLE (GEN- -5)
Evaporator
GEN 5
GEN 5 - EM-1
GEN 5 - EM-1
GEN 5 - EM-1
GEN 5 - EM-1
GEN 5 - EM-7
GEN 5 - EM-7
GEN 5 - EM-2
GEN 5 - EM-2
GEN 5 - EM-2
GEN 5 - EM-2
Table 8-3 SPLIT- -SYSTEM GEN- -5 WITH MICRO- -CHANNEL CONDENSER
Evaporator
EM--1, EM--9, IW--1
EM--1, EM--9, IW--1
EM--2, IW--2
EM--2, IW--2
EM--7, IW--14
EM--7, IW--14
EM--3 (dual loop)
After determining the approximate charge using the above tables, refer to "System Performance Chart" (Table 8-5)
to determine if the correct charge has been obtained.
The data listed in Table 8-1 trough Table 8-3 is based on a 20 foot liquid line. Increase the charge by 0.5 pound for each
additional 10 feet of liquid line.

8.1.5 Evaporator Tie-In

.
When an after market in-dash evaporator is added to a standard system the refrigerant charge will increase by
approximately 1 pound.
If attempting to use a CM-2 condenser with a tie-in call Carrier Transport Air conditioning technical support for an
application review.
T--311

Figure 1-11 Micro-Channel Style Condenser Assembly

Condenser
All Series
CM-2 or CM-4
CM-11
CM-3
CM-7
CM-2 or CM-4
CM-11
CM-2 or CM-4
CM-11
CM-3
CM-7
Condenser
Micro- -Channel
CM--2
CM--3
CM--2
CM--3
CM--2
CM--3
(2) CM--3
Recommended
R134a Charge
4.75 Pounds
5.00 Pounds
5.25 Pounds
6.25 Pounds
4.00 Pounds
4.25 Pounds
4.50 Pounds
4.75 Pounds
5.00 Pounds
6.00 Pounds
Recommended
R134a Charge
3.25 Pounds
3.75 Pounds
3.00 Pounds
3.50 Pounds
2.75 Pounds
3.00 Pounds
4.50 Pounds (each)
8--2
Recommended
Oil Charge*
9.5 Ounces
10.0 Ounces
10.5 Ounces
12.5 Ounces
8.0 Ounces
8.5 Ounces
9.0 Ounces
9.5 Ounces
10.0 Ounces
12.0 Ounces
Recommended
Oil Charge
6.5 Ounces
7.5 Ounces
6.0 Ounces
7.0 Ounces
5.0 Ounces
6.0 Ounces
9.0 Ounces (each)