Figure 4- -19 Hose/Harness/Drain Line Tie-Wraped
To Hose Cover Backs
Figure 4- -17 Correct Hose/Harness Corner
Routing (Window Not Blocked)
Trim-Lock
Insulated Clamp
Figure 4- -20 Hose/Harness Clamped to Wall
At this time the evaporator can be mounted. Refer to
Section 2 for the proper procedures for installing a rear
mounted evaporator assembly.
12.You may now make the appropriate connection to
the evaporator.
Proper hose to fitting clamping is critical. Do not attempt
to attach any hose or fitting until you have familiarized
yourself with Carrier Transport Air Conditioning
Quick-Click hose/fitting crimping procedures.
4.4 EVAPORATOR HOSE ROUTING, OUTSIDE
THE BUS WALL
The evaporator has been previously installed. Refer to
Section 2 for the proper procedures for installing a rear
Figure 4- -18 Side-Mounted Routing (Top)
mounted evaporator assembly.
4--6
T--311