System Requirement Label Completion - Carrier Transport Air Conditioning Installation Procedures Manual

11.1 SYSTEM REQUIREMENTS LABEL
The system requirements label must be conveniently
located within the vehicle's engine compartment. This
label, when properly completed by the installer, will give
the servicing technician the refrigerant and oil
charge(s), evaporator(s),
compressor(s) serial numbers, the drive belt(s) number,
mount kit number, the date of installation and the
installer (See Figure 11-1).

11.1.1 System Requirement Label Completion

To complete the system requirement label do the
following:
1. Lift the protective acetate cover to expose the blue
and white data tag.
2. Enter the serial
components) compressor(s),
condenser(s) where designated on the tag.
3. Enter the type of refrigerant used and the amount
that was placed into each system, in pounds and
condenser(s),
numbers of the (system
evaporator(s),
Figure 11-1 System Requirements Label
ounces. If this is a dual system, designate on tag which
system (#1 or #2) is front (F) or rear (R), drivers (D) or
passenger (P) side.
4. Enter (print) the type oil used and the amount, in
ounces.
and
5. Enter the compressor(s) drive belt(s) part number
or length.
6. Enter the mount kit (if used) part number.
7. Enter (print) your company's name (Installer).
8. Enter the date the installation was completed.
9. Determine where the label will be placed within the
engine compartment. Wipe that area clean.
10. Remove the covering from the back of the label,
exposing the adhesive surface. Place the label in the
pre-determined location.
and
11. Carefully remove the protective covering from the
clear acetate. Carefully smooth the protective acetate
over the data tag label.
11--5
01- 22- 07
T--311