Carrier Transport Air Conditioning Installation Procedures Manual page 98

INSTALLATION CHECK-OUT, CONDENSER - Continued:
____ ____ Are exposed terminals/connections protected with an anti-corrosive coating?
____ ____ I
____ ____
Is condenser properly grounded to the chassis?
EVAPORATOR AREA:
YES NO
____ ____
Is evaporator(s) mounted securely to the bus roof? Either through the roof using
hardware supplied by Carrier Transport Air Conditioning or by Carrier Transport Air
Conditioning approved OEM supplied mounting brackets?
____ ____
If evaporator is mounted with carriage bolts through the roof, are the roof rails
and bolts tight and sealed with caulking?
____ ____
Are refrigeration hoses routed properly? In hose covers or in the skin of the bus.
Hose Covers must never cover Bus windows.
____ ____
Are two drain lines installed and running to opposite sides of the bus?
____ ____
Are drain lines running downhill?
____ ____ Are condensate valves (Kazoos) installed on drain line outlets?
____ ____
Is suction fitting and block valve (TXV) wrapped with "no-drip" tape to prevent
condensate drip?
____ ____
Is suction hose covered with insulation to prevent condensate drip?
____ ____
Are blowers/fans running in the proper direction? Through evaporator filter and pushing
into the
____ ____
Are evaporators properly grounded? Evaporator must be grounded on the nearest vehicle
chassis rail using the ground wire (8 Gauge) supplied with installation kit.
____ ____
If ducted system, is ductwork properly mounted and trimmed?
____ ____
Are all required grills/louvers installed in the ductwork?
REFRIGERATION HOSE AND ELECTRICAL HARNESS ROUTING:
YES NO
____ ____
Is system wiring harnesses and refrigerant hoses protected from sharp edges, heat sources
and moving parts? Refrigerant hoses and harnesses must be protected from heat sources,
sharp edges and moving parts.
____ ____
Are insulated clamps used to support the hose and harness? Refrigerant hose should be
supported with insulated clamps wherever possible. Tie-wraps should only be used to bundle
together wiring and hose assemblies.
________
T--311
f and when needed, is condenser(s) protected from road
passenger compartment.
Are the "Quick-Click" fittings properly clamped to the "Quick-Click" hose?
-sling?
11--2
air