Figure 2-55 In-Wall With Trimmed Cover (Front); Figure 2-56 In-Wall Cover - Locking Tabs - Carrier Transport Air Conditioning Installation Procedures Manual

Transport air conditioning, split systems generation 4 & 5

Table of Contents

Cut-Out Too High

Mounting Screw

Locking Tab

To install the metal cover to the front mounted IW-1

assembly, carefully line-up and place the two slotted

mounting tabs above the IW-1 drain pan and push down

(See Figure 2-56). The cover should slide into the drain

pan easily, with very little resistance. Making sure the

top holes are lined up properly, secure the cover with

two screws supplied with the installation kit. Tug on the

bottom of the cover to make sure it is firmly secured to

the IW-1.

NOTE

If the metal cover mounting tabs do not slide

into the drain pan easily you will have to space

out the IW-1 assembly with thin washers placed

between the bus structure rails and the IW-1

mounting plates. Do not space the IW-1 out too

far or the cover will not be snug against the front

wall.