Connecting Network Devices; Connectors; Cable Specifications - Brocade Communications Systems ICX 6430 Hardware Installation Manual

Assigning an IP address to a virtual routing interface
A virtual interface is a logical port associated with a Layer 3 Virtual LAN (VLAN) configured on a Layer 3 device. You can configure
routing parameters on the virtual interface to enable the Layer 3 device to route protocol traffic from one Layer 3 VLAN to the other,
without using an external router.
NOTE
The device uses the lowest MAC address on the device (the MAC address of port 1 or 1/1/1) as the MAC address for all ports
within all virtual interfaces you configure on the device.
Enter commands similar to the following to add a virtual interface to a VLAN and configure an IP address on the interface.
Brocade(config)# vlan 2 name IP-Subnet_10.1.2.1/24
Brocade(config-vlan-2)# untag 1/1/1 to 1/1/4
Brocade(config-vlan-2)# router-interface ve1
Brocade(config-vlan-2)# interface ve1
Brocade(config-vif-1)# ip address 10.1.2.1/24
The first two commands in this example create a Layer 3 protocol-based VLAN named "IP-Subnet_10.1.2.1/24" and add a range of
untagged ports to the VLAN. The router-interface command creates virtual interface 1 as the routing interface for the VLAN. The last
two commands change to the interface configuration level for the virtual interface and assign an IP address to the interface.
Syntax: router-interface ve num
Syntax: interface ve num
Deleting an IP address
Enter a command similar to the following to delete an IP address.
Brocade(config-if-1/1/1)# no ip address 10.1.2.1
This command deletes IP address 10.1.2.1. You do not need to enter the subnet mask.
To delete all IP addresses from an interface, enter the following command.
Brocade(config-if-1/1/1)# no ip address *
Syntax: [no] ip address { ip-addr | * }

Connecting network devices

Brocade devices support connections to other vendors' routers, switches, and hubs, as well other Brocade devices.

Connectors

For port pinouts, refer to the

Cable specifications

For information about supported transceivers and cable lengths and types, refer to the product data sheet.
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
Part Number: 53-1003617-03
Brocade ICX 6430 and ICX 6450 Stackable Switches Technical Specifications

Connecting network devices

on page 91.
73